The Basics:
The kit consists of two sticks of DDR, each sporting 1024MB. The oversized black aluminum heatspreader features a high gloss finish and bright green labels to identify the modules. The top edge of the DDR features a total of 18 LEDs that indicate the memory's activity with an assortment of red, yellow, and green lights.
 
One issue with these modules being taller than your typical DDR is that small form factor cases may not be able to use them. I own an mATX case and a mini-ITX case, neither of which can use the Pro series of DDR from Corsair, as it simply does not fit with the limited clearance height available. Owners of mATX, mini-ITX, and other small form factor cases/cubes should double check that they have the clearance necessary to use this 1.75" tall memory before dropping any money on it.
The images below provide a close up of the labels found on each module. The below left image shows the important stuff; part number, serial number, size, speed, timings, etc.
 
If these modules didn't have the LEDs on the top, I would consider removing the heatspreader in order to show off the chips underneath. But, in order to avoid damage to the LEDs, you only get an edge view where you can see that the heatspreader is well affixed to the chips. Heat transfer should be fine, as the thermal tape makes good contact on both sides.
 
Since the chips themselves won't be exposed for examination, we'll have to rely on published data from Corsair that says these have 64Mx8 Infineon chips.
The animated GIF shown below was actually created using another set of Corsair Pro DDR, but the effect is the same. If you haven't seen them in action before, this is roughly what the LEDs look like when in action.
|
|
