| OCZ Technology GameXStream 700W Power Supply Unit
|
The Cables:
This is probably the absolute best wrapping job I've seen on any power supply. Many times the wrapping starts a few inches after the cables have exited the power supply, but OCZ Technology's wrapping starts inside the power supply, so you do not get any exposed wires until you're at the connectors.
The below left image shows where the cables exit the power supply. In addition to a great wrapping job, OCZ has a nice heavy duty piece of plastic surrounding the cables, so they can not be cut by rubbing against the hole in the housing.
 
In the above right image we see the bundle of cables as they were shipped. Many power supplies have the cables loose, rubber banded, or have a twist tie to keep them together while shipping. As mentioned before, OCZ has used a velcro strap to keep them together. While this does not increase or decrease the performance of the power supply, it is a nice added benefit, as I can use the strap to keep unused cables together after it's installed!
Here you can see the component power cables separated. These cables are very long; in fact the SATA cable are about 3.5 feet long! This is great as it allows you to route the cables as necessary! The top two leads are SATA connections and each lead provides power for three (3) SATA devices. Next you have two leads of four pin Molex connections, and once again each lead provides power for three (3) devices. In addition to the Molex connectors, on each lead there is also a floppy power connector. I really like that OCZ has used easy grip Molex connectors as it makes it much easier when changing components. The final two leads are for PCI Express. In the second picture here, you can see that OCZ has labled the SATA and PCI-E connections. The PCI Express cables are long enough to reach both video card slots, however there was not much slack left in the cable for tidy routing.
 
Here you can see that OCZ Technology has also labeled the motherboard power connectors. The main ATX power is a standard 20-pin connector, with a 4-pin add-on which would allow this to provide power to 24-pin motherboards. The second lead here is a 4-pin and 8-pin motherboard power connector. Your motherboard will determine which of these connectors you need. On my various systems, the Gigabyte K8N-XP SLI requires the use of the 4-pin, while the DFI NF4 Expert requires the use of the 8-pin. Unfortunately, this is the first place I'm slightly disappointed. These connectors do not stay together very well, which can make it a little difficult to install in tight quarters. I would like to see them snap into the other connector or some sort of locking mechanism to keep them together for installation.
|
|
|
|
