View Single Post - Shuttle AN35N Dead?

Doctor Feelgood · Administrator

I have one of these nForce2 Ultra 400 boards that has been pretty cool since I bought it in September... I had it overclocked before at 200 MHz fsb, but didn't keep it there long... but it worked fine.

Last night I was running PCMark04 on it when it froze up... when it booted up again it said it was actually a XP1250+ with memory at 100 MHz (200 DDR)...

So, I went into the BIOS and all the settings were correct, and I rebooted... Same thing... still said 1250+. WTF?

So, then I cleared the CMOS for a while, came back to boot up and now I have nothing!! No beep, no post, nothing but the fans spinning and the drive leds lighting up!

Swapped in different ddr, disconnect/reconnected everything, and nothing changed.

If I take the ddr out and boot, it will beep, and gives the long beeps that indicate memory issues. Weird...

Anyway... Anyone have any ideas? I have already filed an RMA request with Shuttle, and may do so with Newegg (if necessary)... And in the meantime have already ordered an identical replacement from Newegg (off their refurb page)... Bang Head