Dfreak
Rated PG
|
 Posted: Wed, 08 Apr 2009 05:06:37 Post Subject: |
 |
|
Hi, here I am again 
My TB32 worked fine until a few days ago  . When I started up the enclosure, it starts to do a Disk Rebuild (Middle LED: Blinking blue + red on). But after about 20 seconds the Power LED becomes purple (HDD volume degradation) and the middle LED is blinking blue + blinking red (error state). I tried everything: removed all partitions, tried other modes: I always used SAFE50 mode, so I tried also another mode: SAFE33 and RAID1; these 2 also don't work.
All other modes (SPAN, Normal, RAID0) just work fine. So every mode which involves RAID1 doesn't work... Is it possible that the RAID controller of the enclosure is defect?
Dfreak |
|
