Dfreak
Rated PG
|
 Posted: Sat, 13 Dec 2008 07:11:36 Post Subject: |
 |
|
I have it now with 2 1TB harddrives installed. I configured the TB32 in SAFE50 mode. I hooked it al up and started to copy all data I can't afford to loose on the safe partition, al other data on the big partition. It copied all night long and when I woke up everything was done, all LED's were blue. I shutted the TB32 down and I booted it again a few hours later. Now I see the 2 volume's and everything works, but the middle LED is red with flashing blue: in the manual is that it's doing a disk rebuild. The bottom LED is red with blue (just HDD activity). Now, is this all normal, why does it have to do a disk rebuild?  |
|
