acruxksa
Rated XXX
|
 Posted: Sat, 27 Jan 2007 05:18:17 Post Subject: |
 |
|
It would definitely be possible to boot FC 6 from a cd or floppy and then have it load your setup on the raid array, but to boot from the raid array may be a little more difficult. I'm not saying it can't be done, but I personally have never done it. Usually I put the linux boot partition on a single drive and then the root partition on a raid array.
My advice would be to use either a floppy or cdrom to boot your linux nvraid system. It would be the easiest solution although it may be a little inconvenient. Chances are you can boot your linux installation from the FC6 installation disk.
I know this isn't the answer you were looking for, but I believe NVRAID is actually a partial if not total software solution so lack of proper driver support in linux is likely more nvidia's fault than anyone else's.
It may be possible, but I don't know how. I'm no expert though, so someone else may have a better solution.
_________________
 |
|
