rinnan
Rated PG
|
 Posted: Mon, 08 Aug 2005 05:02:38 Post Subject: sanding |
 |
|
Something I read suggests sanding the heat pipe until the contact surface is smooth. I noticed that it's quite rough, maybe that's it? As for height of the components, that seemed to be a good fit on the M12000. I guess another factor might be that it IS an MII12000, which I suppose might take more juice than an M10000, don't know.
Tomorrow I'm going to work on all of this, when our local electronics supply store opens. Arctic Silver 3, or whatever's best. Also going to look at disk-on-chips, so I can put on LinuxBIOS.
Eventually these are going into products for customers so I don't want it to look like it's a computer booting!  |
|
