View Single Post - Raid 0 and XP repair options

sweetpain · Rated PG

It has been a while since I have been stumped but now I am. I have a PC that is using an on board Raid controller. It is set for Raid 0 (used for digital editing). Today at boot up we get a message that a system file is missing or currupt. I can fix that no problem right? Yea I wish.

Here is the deal....when I load recovery console it does not see C:....don't know why because I did load the third part driver at start up. Now I say lets give doing a repair a shot...no luck there either...XP can see both drives but not as one. So I load the driver so XP can see the disks but not the strip set.

Any ideas??? I am at a loss...and the kicker is if I could just get into my operating system I could solve my original problem in a flash.

I even tried ERDCommander and it did see the drives but could not tell what operating system was running. Again I suppose because it can't read them as one drive.

Thanks