Doctor Feelgood
Administrator
|
 Posted: Sun, 17 Oct 2004 09:07:26 Post Subject: |
 |
|
I just reviewed an Asetek kit and it was tough fitting everything in my case, which is pretty big!! I would just look for a case with a lot of open space inside, 120mm fan mounts pre-cut into the case, and one that doesn't have the hard drive bays permanently mounted at the bottom front of the case...
You could then get a kit with a 120mm radiator in there pretty easy, and have room for the reservoir and pump up near the front of the case...
I have a different water cooling kit in an AMS gTower case, and it worked well, because the lower drive cage was removable, and it had a 120mm fan mount on the back... I bet similar cases from Antec or CoolerMaster would work well, too. |
|
