Accessories/Cables:
The temperature monitor fan controller fits in a standard 3.5 inch bay which will display temperature in Celsius or Fahrenheit of either the sensor (psu t) near the exhaust 80mm fan or on the heatsink (sink t), depending on which connection is used. It has a knob for fan speed control to reduce the noise (low) or lower the temperature (high) and an auto setting that will let the controller manage the best temperature/noise ratio.
The image below shows a wire on the power supply labeled "smart protection" which is for the controller to communicate with the PSU.
Cables Included:
» 1 x 20 + 4-pin main power cable – 50 cm
» 1 x Fan Controller Auto Protection Sensor – 1 cm
» 1 x Molex connector cable – 65 cm (Includes three Molex connectors 35 + 15 + 15cm)
» 2 x Molex connector cable – 80 cm (Includes three Molex connectors 35 + 15 + 15cm)
» 2 x Serial ATA connector cable – 70 cm (Includes two Serial ATA connectors 55 + 15cm)
» 1 x 4/8-pin +12 V connector – 45 cm (Includes one 4-pin and one 8-pin + 12 V connectors)
» 1 x Molex to Floppy connector cable – 14 cm (Includes two floppy connectors
» 1 x EMI-shielded HDD/VGA cable – 60 cm (Includes one HDD/VGA connector)
» 1 x EMI-shielded PCI Express cable – 15 cm (Includes one PCI Express connector)
A modular power supply can really make a big difference with the wire clutter that comes with high end computers housing many components; and it also improves the airflow within the case.
The ability to choose which cables you actually need eliminates some extra cables hanging around inside the case. The cables provided are very nice, vary in length, have a good flex range, most are sleeved, two are EMI-shielded, and the Molex cables have nice grips for easy removal.
